VALTEK MATRIX RAIL HEATER INJECTOR

Quantity

  • all regulations please read on the page "store privacy policy" all regulations please read on the page "store privacy policy"
  • All Items Are Posted Out The 1- 2  Working Day After Cleared Payment


All Items Are Posted Out The 1- 2 Working Day After Cleared Payment
  • Return in United Kingdom  in 14 working days 
Return  outside United Kingdom  30 working days ONLY UNUSED PARTS
Return in United Kingdom in 14 working days Return outside United Kingdom 30 working days ONLY UNUSED PARTS
Electric heater for injection bar.
This element is used to heat up the injector bar, which is extremely useful when switching the power source at low ambient temperature for the first time. The use of the heater allows for faster heating of the moulding to working temperature, easier switching to gas, avoidance of rippling and jerking.
The heater is compatible with injection mouldings such as Valtek, Matrix HD544, Matrix XJ544, Rail, IG1, Apache.
The heater is mounted by screwing it with a full aluminium surface to the skirting board (the contact between the skirting board and the heater should be lubricated with heat-conducting silicone, thermo-conducting paste) by means of screws or clamps. The heater should be connected to a voltage of +12V under the ignition (the voltage appears only when the key is turned on and the ignition is turned on). Operation is indicated by a diode embedded in the heater. After reaching the maximum temperature (approx. 60*C) the heater switches off automatically.
The heater is designed for vehicles with a voltage in the 12V system. It is not recommended to connect the heater directly to the battery, it may be discharged.
Technical data:
- Power supply: 12V
- Current consumption: 2,8A
- Maximum temperature: 60°C
- The length of the heater: 100mm
- Width of the heater: 25mm
- Height of the heater: 10mm

883